BMS integration

• No additional application software is required for integration into the BMS – there’s no need for additional training or studying complex manuals.

• You are not limited by any built-in control algorithms from the manufacturer.

• The entire application remains fully under your supervisory system’s control.

The Weesion W10 series was developed for seamless integration into BMS systems using BACnet MS/TP or Modbus RTU communication protocols.

Communication lines of the modules can be connected directly to DDC controllers supporting these protocols, regardless of the manufacturer.

For integration into IP-based BMS systems, BACnet MS/TP–IP or Modbus RTU–IP gateways can also be used.

Each module type in the W10 series is equipped with a switch for the 120 Ω EOL termination resistor at the end of the RS485 line.

W10 modules communicating via BACnet support BACnet device discovery, which means that after connecting them to the supervisory system, all devices and their I/O points (BACnet objects) can be detected and loaded with one click.